Skip navigation

The small gray logos on the outside of the bulwarks

The small gray logos on the outside of the bulwarks

We decided to add Sea Eagle’s name and logo to the front and sides of the boat. There was a nice Sea Eagle graphic on the transom, but you really couldn’t see the name of the vessel due to the indent. I called Eric Nelson at Tacoma Rubber Stamp and sent over the logo that we’d be using for our shirts. He scaled the logo up and cut out the vinyl.

The small gray logos went on the outsides of the bulwarks easily, fooling us into thinking this was going to be an “easy” boat job (finally!). Then we started on the Large black graphics across the front of the flybridge and the “fun” began. The compound curve of the flybridge and the big straight line all the way across the top of the logo I designed didn’t like each other much (moral, don’t let an engineer design artwork). After some head scratching, we hinged the vinyl side to side and rolled it out.

The large Black Graphic on the Front of the Sea Eagle

The large Black Graphic on the Front of the Sea Eagle

I think the graphics project turned out pretty well, but time will tell if I want to keep the big black and white logo across the front or not. The gray logos on the sides are a lot more subtle. Any opinions?

I also finally got around to changing the oil, plugs and filters of the 40 HP Honda on the large dingy. Just a few more jobs (and a few more days) and we should be ready for the San Juan’s.

Now where did that list of boat repairs go….

New Graphics across the front of the Fly Bridge

New Graphics across the front of the Fly Bridge